MBRP S5106 - Manual (Page 3)

Regular Cab Models
1. Temporarily install the muffler by placing hangers located on muffler into factory rubber insulators. Now measure from the front
of the muffler to the “Y” pipe. This will give you the required length to cut the extension pipe to. Remove the muffler.
2. Cut the extension pipe to the required length. Install the expanded end of the extension pipe over the factory exhaust system
behind the “Y” pipe and install muffler onto extension pipe.
3. Place hangers located on muffler into factory rubber insulators.
4. Loosely install the driver side over axle pipe. This pipe will connect to the outlet closest to the drive shaft.
5. Feed the passenger side over axle pipe over the axle and install it loosely.
6. Feed the expanded end of the driver side tail pipe from the rear of the vehicle over the axle and connect it to the driver side
over axle pipe.
7. Move the driver side tail pipe into approximate position. Using the factory hole provided in the frame located directly above the
tail pipe hanger, attach the hanger provided using the supplied hardware.
8. Remove the factory rubber insulator for the factory tail pipe. Now feed the expanded end of the passenger side tail pipe from
the rear of the vehicle over the axle and loosely connect it to the passenger side over axle pipe.
9. Move the passenger side tail pipe into approximate position. Using the factory hole provided in the frame located directly above
the tail pipe hanger, attach the hanger provided using the supplied hardware.
10. Install the mirror polished tips. It is recommended to install them at this point to assist with the final system alignment.
11. Install the hanger clamp around the front muffler joint and into the factory rubber insulator located on the frame near the front
of the muffler.
12. Install provided clamps to the pipe connections where required. Align the exhaust as required before tightening clamps.
13. Starting at the front of the exhaust tighten all clamps and connections.
14. Check along the whole length of the exhaust system to ensure that there is adequate clearance around the spare tire, fuel and
brake lines or any wiring. If any interference is detected relocate or adjust.
Congratulations! You are ready to begin enjoying the improved performance and driving experience of your MBRP Inc. Cool Duals
system. We hope you enjoy your purchase.
S5106 © 1/08 Page 3 of 3