MBRP S5122 - Manual (Page 2)

2004-05 DODGE RAM SRT-10
8.3L V10 REGULAR CAB
Removal of stock system:
1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers and rubber insulators.
2. Loosen the clamps behind the muffler and remove the tail pipes from the vehicle.
3. Loosen the clamps located in front of the muffler and remove it from the vehicle.
Installation of MBRP Inc Performance Exhaust:
1. Slide the 2.5”Clamps over the two ends of the factory exhaust and slide the Muffler and
Collector Assembly onto the factory exhaust pipes. Now slide the hangers located on the Muffler
and Collector Assembly into the rubber insulators.
2. Slide the 4” Clamp over the Over Axle Pipe and slide it into the Muffler and Collector
Assembly. Now slide the hanger located on the Over Axle Pipe into the rubber insulator.
3. Slide the 4” Clamp over the Tail Pipe and slide it into the Over Axle Pipe. Now slide the
hanger located on the Tail Pipe into the rubber insulator.
4. Install the Mirror Polished Tip but do not tighten at this point.
5. Align the exhaust for best fit and starting at the front of the exhaust, tighten all clamps and
connections.
6. Before starting the vehicle check along the whole length of the exhaust system to ensure that there
is adequate clearance around the fuel and brake lines or any wiring. If any interference is detected
relocate or adjust.
Congratulations! You are ready to begin enjoying the improved performance and driving experience
Of your MBRP Inc performance exhaust system. We hope you enjoy your purchase.
S5122 © 8/06 Page 2 of 2