MBRP S5334 - Manual (Page 3)

S5334 © 4/14 PAGE 3 OF 3
4. Loosely install a 2.5” Clamp on the exit of the muffler and insert the
Over Axle Pipe into the muffler. Slide both hangers into the stock rubber
insulator. Refer to Figure 5.
5. Loosely install a 2.5” Clamp on the tail of the Over Axle Pipe and
install the Tail Pipe into the Over Axle Pipe. Finally slide the Tail Pipe
hanger into the stock rubber isolator. Refer to Figure 6.
6. Install the Exhaust Tip on to the Tail Pipe. Position the tip as desired
and use an 8mm wrench to tighten. Re-adjustment may be required after
entire system is tightened down. Refer to Figure 6.
Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of your MBRP
Inc. performance exhaust system. We know you will enjoy your purchase.
Figure 5
Figure 6