MBRP S5504 - Manual (Page 3)

S5504 © 04/08 PAGE 3 OF 3
2. Slide a 3” Clamp over the Tail Pipe and loosely install the Over Axle
Pipe onto the Tail Pipe. Refer to Figure 5.
3. Slide a 3” Clamp over the outlet side of the Muffler. Install the
Muffler to the Over Axle Pipe. Slide a 3” Clamp onto the inlet of the
Muffler then install the Extension Pipe and Flange.
Refer to Figure 6.
4. Install the Extension Pipe Flange to the existing flange using the
fasteners provided. Refer to Figure 7.
5. Install the hanger for the Over Axle Pipe to the existing rubber
insulator. Refer to Figure 8.
6. Install and adjust the Exhaust Tip to suit. Using a 17mm wrench
tighten the lock bolt located on the Exhaust Tip. Refer to Figure 9.
7. Align the exhaust as required. Starting at the front of the exhaust,
tighten all clamps and connections.
8. Check along the whole length of the exhaust system to ensure that
there is adequate clearance around the spare tire, fuel and brake lines or
any wiring. If any interference is detected relocate or adjust.
Congratulations! You are ready to begin experiencing the improved
power, sound and driving experience of your MBRP Inc. performance
exhaust system. We hope you enjoy your purchase.
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9