MBRP S5060 - Manual (Page 3)

S5060 © 01/10 PAGE 3 OF 3
2. Slide a 3” Clamp over the rear of the Extension Pipe and install the
Muffler onto the Extension Pipe. Refer to Figure 7.
3. Slide a 3” Clamp over the outlet side of the Muffler. Feed the Over
Axle Pipe into the outlet of the Muffler. Install the Over Axle Pipe hangers
into the factory rubber insulators located directly above the hangers.
Refer to Figure 8.
4. Slide a 3” Clamp onto the Over Axle Pipe and install onto the Tail Pipe.
Slide the Tail Pipe hanger into the rubber insulator located on the frame.
Refer to Figure 9.
5. Install and adjust the Exhaust Tip to suit. Use a 17mm wrench to tighten
the lock bolt located on the Exhaust Tip.
6. Align the exhaust as required and starting at the front of the system,
tighten all clamps and connections.
7. Check along the whole length of the exhaust system to ensure that there
is adequate clearance around the spare tire, fuel and brake lines or any
wiring. If any interference is detected relocate or adjust.
Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of
your MBRP Inc. performance exhaust system. We know you will enjoy your purchase.
Figure 6
Figure 7
Figure 8
Figure 9