MBRP S5062 - Manual (Page 2)

S5062 © 01/13 PAGE 2 OF 3
Removal of Stock System:
1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers
and rubber insulators.
2. The tail pipe will need to be cut to clear the rear axle.
Refer to Figures 1&2.
3. Remove the clamp behind the catalytic converter and save the
clamp for the installation. Refer to Figure 3.
4. Remove the hangers from the rubber insulators. Remove the exhaust from
underneath the vehicle. Refer to Figure 4.
Installation of MBRP Inc. Performance Exhaust:
1. Install the Extension Pipe to the existing flange using the clamp removed
earlier. Leave the hardware loose enough for some adjustment.
Refer to Figure 5.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5