MBRP S5310 - Manual (Page 2)

S5310 © 12/12 PAGE 2 OF 3
2007-2013 Toyota FJ Cruiser 4.0L
Removal of stock system:
1. Apply a penetrating lubricant liberally to all exhaust
fasteners, hangers and rubber insulators.
2. Remove the bolts and springs holding the front flange together
and disconnect exhaust system. Do not discard this hardware it will
be reused during the installation Refer to Figure 1.
3. Remove hardware from Flange behind muffler. Remove the
hangers from the rubber insulators. Remove the exhaust from
the vehicle. Refer to Figures 2 & 3.
Installation of MBRP Inc. Performance Exhaust:
1. Install Extension Pipe to the flange using the existing
hardware and springs from the removal. Refer to Figure 4.
2. Slide a 2 ½” Clamp over the Extension Pipe and install muffler
onto the Extension Pipe. Refer to Figure 5.
Figure 1
Figure 2
Figure 3
Figure 4