MBRP S5134 - Manual (Page 3)

S5134 © 04/08 PAGE 3 OF 3
Installation of MBRP Inc. Performance Exhaust:
1. Slide the 2 1/2” Clamp onto the factory “Y” pipe then install the
Extension Pipe. Install the Extension Pipe hanger into existing rubber
isolators. Refer to Figure 5.
2. Slide a 3” Clamp over the Extension Pipe and install the Muffler onto
the Extension Pipe. Loosely reattach the ground strap.
Refer to Figure 6.
3. Slide a 3” Clamp over the outlet side of the Muffler. Position the Over
Axle Pipe over the axle and loosely attach it to the Muffler. Install the
Over Axle Pipe hangers into the factory rubber insulators. Refer to
Figure 7.
4. Slide a 3” Clamp over the Tail Pipe and attach it to the Over Axle
Pipe. Refer to Figure 8.
5. Install and adjust the Exhaust Tip to suit. Using a 17mm wrench
tighten the lock bolt located on the Exhaust Tip.
6. Align the exhaust as required. Starting at the front of the exhaust,
tighten all clamps and connections. Check along the whole length of the
exhaust system to ensure that there is adequate clearance around the
spare tire, fuel and brake lines or any wiring. If any interference is
detected relocate or adjust.
Congratulations! You are ready to begin experiencing the improved
power, sound and driving experience of your MBRP Inc. performance
exhaust system. We hope you enjoy your purchase.
Figure 5
Figure 6
Figure 7
Figure 8
Figure 9