MBRP S5222 User Manual
Page 2
S5222 © 03/10
PAGE 2 OF 3
2009 - 2010 FORD F150
Removal of Stock System:
1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers and
rubber insulators.
2. Loosen the flange located behind the “Y” pipe.
Refer to Figure 1.
3. Loosen the clamp located in front of the muffler.
Refer to Figure 2.
4. Remove the hangers from the rubber insulators and remove the exhaust
from the vehicle. If a hoist or hydraulic lift is not being used the tail pipe may
need to be cut to clear the rear axle.
Refer to Figure 3.
Installation of MBRP Inc. Performance Exhaust:
1. Install the Front Pipe to the existing flange using the fasteners provided.
Refer to Figure 4.
Note: the Extension Pipe will not be required on some models.
Figure 1
Figure 2
Figure 3
Figure 4
Model
Bed
Length
Wheelbase
Extension
Pipe
Required
Shortening
Front Pipe
Required
Regular Cab (RC)
6.5’
145”
No
19”
Regular Cab (RC)
8’
145”
No
No
SuperCab (EC)
6.5’
145”
No
No
SuperCab (EC)
5.5’
133”
No
11”
SuperCrew (CC)
6.5’
157”
Yes
No
SuperCrew (CC)
5.5’
145”
No
No