MBRP S5042 - Manual (Page 3)

Installation of MBRP Inc. Performance Exhaust:
11. Loosely attach the Extension Pipe at the flange
using the hardware provided and slide hanger into
the rubber insulator located on the frame. Refer to
Figure 5.
2. Slide a Band Clamp over the Extension Pipe and
install muffler onto the Extension Pipe. Refer to
Figure 6. Refer to illustration on page 1 showing the
flow direction of the muffler.
3. Slide a Band Clamp over the outlet side of the
Muffler. Then feed the Over Axle Pipe over the axle
and loosely attach it to the muffler. Install the pipe
hangers into the factory rubber insulator. Refer to
Figure 7.
4. Slide a Band Clamp over the Tail Pipe and install
onto the Over Axle Pipe. The slide hanger into
rubber insulator located on the frame.
Refer to Figure 8.
5. Align the exhaust as required. Starting at the front of
the exhaust, tighten all clamps and connections.
6. Check along the whole length of the exhaust
system to ensure that there is adequate clearance
around the spare tire, fuel and brake lines or any
wiring. If any interference is detected relocate or
adjust.
Congratulations!
You are ready to begin enjoying the improved
performance and driving experience of your MBRP Inc.
performance exhaust system. We hope you enjoy your
purchase.
Figure 8
Figure 5
Figure 7
Figure 6
S5042 © 12/07 PAGE 3 of 3