MBRP S5520 User Manual

Page 3

S5520 © 03/13

PAGE 3 OF 3

Installation of MBRP Inc. Performance Exhaust:

1. Install the Muffler to the existing flange using the fasteners provided.
Slide the Muffler hanger into the existing rubber isolator.
Refer to Figure 4.

2. Slide the 2 ½” Clamp over the Muffler outlet then install the Tail Pipe to
the Muffler. Use the fasteners provided to install the Exhaust Hanger through
the existing hole in the frame located just above the Tail Pipe hanger. Install the
Tail Pipe hanger into the rubber isolator. Refer to Figures 5 & 6.

3. The existing Tail pipe hanger can be removed from the outside frame rail.
Refer to Figure 7. Align the exhaust as required. Starting at the front of the exhaust,
tighten all clamps and connections.

4. Check along the whole length of the exhaust system to ensure that there is adequate
clearance around the spare tire, fuel and brake lines or any wiring. If any interference
is detected relocate or adjust.

Congratulations! You are ready to begin experiencing the improved power, sound

and driving experience of your MBRP Inc. performance exhaust system. We know