MBRP S5402 - Manual (Page 3)

S5402 © 12/12 PAGE 3 OF 4
Installation of MBRP Inc. Performance Exhaust
1. Install the Driver Side Front Pipe using one of the provided
2 ½” Gasket and existing hardware when ever possible. The nuts
can be replaced with the 10mm Flange Nuts. Leave hardware
loose enough for some adjustment.
Refer to Figure 6.
2. Slide a 2 ½” Band Clamp over the Extension Pipe and install to the
Driver Side Front Pipe. Refer to Figure 7.
3. Slide the existing factory hanger onto the Extension Pipe and
reattach to the vehicle. Refer to Figure 8.
4. Install the Passenger Side Front Pipe using a 2 ½” Gasket and
existing hardware whenever possible. The nuts can be replaced
with the 10mm Flange Nuts. Leave hardware loose enough for
some adjustment. Refer to Figure 9.
5. Slide two 2 ½” Band Clamps onto the Muffler and attach to the
Passenger Side Front Pipe and the Extension Pipe. Leave the
2 ½” Band Clamps loose enough for some adjustment.
Refer to Figure 10.
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10