MBRP S5076 - Manual (Page 3)

S5076 © 01/13 PAGE 3 OF 3
3. Slide a 3 1/2” Clamp onto the rear of the Muffler. Feed the Over Axle Pipe
into the rear of the Muffler. Install the hanger on the Over Axle Pipe onto the
existing rubber insulator. Refer to Figure 6.
4. Install the Tail Pipe hanger into the factory rubber insulator located directly
above the hanger and attach to the Over Axle Pipe using a 3” Clamp. Refer
to Figure 7.
5. Install and adjust the Exhaust Tip to suit. Tighten the bolt located on the
Exhaust Tip. Refer to Figure 8.
6. Align the exhaust as required before tightening clamps. Starting at the front
of the exhaust tighten all clamps and connections. Check along the length of
the exhaust system to ensure that there is adequate clearance around the spare
tire, fuel and brake lines or any wiring. If any interference is detected relocate
or adjust.
Congratulations! You are ready to begin experiencing the improved power,
sound and driving excitement of your MBRP Inc. performance exhaust system.
We know you will enjoy your purchase.
Figure 6
Figure 7
Figure 8