MBRP S5032 - Manual (Page 2)

S5032 © 01/13 PAGE 2 OF 3
Removal of Stock System:
1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers
and rubber insulators.
2. Remove the hangers from the rubber insulators and remove the exhaust
from the vehicle. The tail pipe will need to be cut to clear the rear axle.
Refer to Figures 1&2.
3. Remove the hardware holding the front flange together and disconnect
exhaust system. Refer to Figure 3.
4. Remove the exhaust from underneath the vehicle. Refer to Figure 4.
Installation of MBRP Inc. Performance Exhaust:
1. Loosely attach the Extension Pipe to the flange using the fasteners
provided. Slide the Extension Pipe hanger into the factory rubber insulator
located on the frame. Refer to Figures 5 & 6.
Figure 1
Figure 2
Figure 3
Figure 4
Figure 5