MBRP S6170409 - Manual (Page 2)

S6170 © 06/14 PAGE 2 OF 2
2014 RAM 1500 3.0L ECODIESEL
Removal of Stock System:
1. Apply some penetrating lubricant liberally to all exhaust fasteners, hangers
and rubber insulators.
2. Loosen the nut on the band clamp located behind the particulate filter.
3. Remove the hangers from the rubber isolators on the vehicle and remove
the stock muffler and tailpipe.
Installation of MBRP Inc. Performance Exhaust:
1. The Extension Pipe provided is pre-cut for the 149” wheelbase vehicle
configurations. For 140” wheelbase vehicles, cut 9” off of the straight end of
the Extension Pipe.
2. Slide the 3” Clamp over the expanded end of the Extension Pipe and install it
onto the end of the particulate filter exhaust pipe. Line up the Extension Pipe slot
with the locator on the top of the stock pipe. Do not fully tighten the 3” Clamp
yet. Refer to Figure 1
3. Slide the other 3” Clamp onto the other end of the Extension Pipe, and then
install the Y-Pipe. Leave the clamp loose enough to allow the Y-Pipe to be
adjusted.
4. Slide the 2 ½” Clamps over the other end of the Y-Pipe and insert the Driver
and Passenger-Side Over-Axle Pipes into each outlet while also inserting the
hangers into the OEM rubber isolators. Leave the clamps loose enough to allow for
adjustment. Refer to Figure 2
5. Slide another 2 ½” Clamp onto the front end of the Passenger-Side Tail
Pipe and then insert the pipe into the Passenger-Side Over-Axle Pipe, while
also inserting the hanger into the OEM rubber isolator. Again, leave the clamp loose
enough to allow for adjustment. Refer to Figure 3
6. Repeat Step 5 for the Driver-Side Tailpipe, using the supplied Rubber
Isolator in the rear hanger location. Refer to Figure 4
7. Install the Exhaust Tips at the desired position.
8. Finally, align the exhaust as required. Starting at the front of the exhaust,
tighten all clamps and connections.
9. Check along the length of the exhaust system to ensure that there is adequate
clearance around the spare tire, fuel and brake lines, or any wiring. If any
interference is detected, relocate or adjust as necessary.
Congratulations! You are ready to begin experiencing the improved power, sound
and driving experience of your MBRP Inc. performance exhaust system. We hope
you enjoy your purchase.
Figure 1
Figure 2
Figure 3
Figure 4