MBRP S5104 - Manual (Page 3)

Regular Cab Models
1. Temporarily install the muffler by placing hangers located on muffler into factory rubber insulators. Now
measure from the front of the muffler to the “Y” pipe. This will give you the required length to cut the
extension pipe to. Remove the muffler.
2. Cut the extension pipe to the required length. Install the expanded end of the extension pipe over the
factory exhaust system behind the “Y” pipe and install muffler onto extension pipe.
3. Place hangers located on muffler into factory rubber insulators.
4. Feed the tail pipe over the axle and loosely install it into the muffler.
5. Install the tailpipe hanger through the factory rubber insulator.
6. Install the hanger clamp around the front muffler joint and into the factory rubber insulator located on the
frame near the front of the muffler.
7. Install the mirror polished tip. It is recommended to install it at this point to assist with the final system
alignment.
8. Install provided clamps to the pipe connections where required. Align the exhaust as required before
tightening clamps.
9. Starting at the front of the exhaust tighten all clamps and connections.
10. Check along the whole length of the exhaust system to ensure that there is adequate clearance around the
spare tire, fuel and brake lines or any wiring. If any interference is detected relocate or adjust.
Congratulations! You are ready to begin enjoying the improved performance and driving experience of your
MBRP Inc. Performance Exhaust system. We hope you enjoy your purchase.
S5104 © 12/07 Page 3 of 3