Mbrp inc – MBRP S5326 User Manual
Page 3

S5326 © 12/13
PAGE 3 OF 3
4. Connect the expanded end of the Tail Pipe to the Over Axle Pipe with the
remaining the 2 ½” Clamp. Install the hanger into the factory rubber insulator.
Refer to Figure 5.
NOTE: 2013 and newer models require the removal of the factory rubber
insulator and the installation of the 90° Rubber Insulator to the outside
frame mount.
Refer to Figure 6.
5. Install and adjust the Exhaust Tip to suit. Tighten the lock bolt located on
the Exhaust Tip.
Refer to Figure 7.
6. Make sure that the exhaust is properly in place before tightening clamps.
Start at the front of the exhaust system and begin tightening all connections.
Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of your
MBRP Inc.
performance exhaust system. We know you will enjoy your purchase.
Figure 5
Figure 6
Figure 7
- UT6001 (3 pages)
- UT2001 (3 pages)
- UT4001 (4 pages)
- UT8001 (4 pages)
- GM8427 (3 pages)
- GM8425 (3 pages)
- F2313 (2 pages)
- GM8424 (2 pages)
- S6028 (4 pages)
- S6110 (2 pages)
- S6014 (4 pages)
- S6168409 (2 pages)
- S6172409 (2 pages)
- S6210 (4 pages)
- S6132 (3 pages)
- S6002 (4 pages)
- S6122 (4 pages)
- S6106 (3 pages)
- S6006 (5 pages)
- S6162409 (2 pages)
- S6202 (3 pages)
- S6244 (3 pages)
- S6128 (3 pages)
- S6102 (3 pages)
- S6214 (4 pages)
- S6165AL (2 pages)
- S6164AL (2 pages)
- S6206 (4 pages)
- S6100 (3 pages)
- S6167 (3 pages)
- S6166 (3 pages)
- S6156 (2 pages)
- S6157 (2 pages)
- S6150PLM (1 page)
- S6150P (1 page)
- S6150 (4 pages)
- S6224 (3 pages)
- S6020PLM (1 page)
- S6200 (3 pages)
- S6212 (4 pages)
- S6285 (3 pages)
- S6126 (3 pages)
- S6020 (3 pages)
- S6116 (3 pages)
- S6004 (4 pages)