MBRP S5324 - Manual (Page 3)

S5324 © 03/13 PAGE 3 OF 3
3. Loosely install the Over Axle Pipe connecting it to the Muffler outlet with
a 2 ½” Clamp. Install the hangers into the rubber insulator located above the
Over Axle Pipe. Refer to Figure 4.
4. Connect the expanded end of the Tail Pipe to the Over Axle Pipe with the
remaining the 2 ½” Clamp. Install the hanger into the factory rubber insulator.
Refer to Figure 5.
5. Install and adjust the Exhaust Tip to suit. Using a 17mm wrench tighten the
lock bolt located on the Exhaust Tip. Refer to Figure 6.
6. Make sure that the exhaust is properly in place before tightening clamps.
Start at the front of the exhaust system and begin tightening all connections.
Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of your MBRP
Inc. performance exhaust system. We know you will enjoy your purchase.
Figure 5
Figure 6