MBRP S5514 - Manual (Page 3)

S5514 © 12/12 PAGE 3 OF 3
Installation of MBRP Inc. Performance Exhaust
1. Install the Extension Pipe using a 2 ½” Clamp and attaching
to the existing rubber isolator. Leave the clamp loose enough for
some adjustment. Refer to Figure 5.
2. Slide a 2 ½” Clamp over the Extension Pipe and then install the
Muffler to the Extension Pipe. Refer to Figure 6.
3. Slide a 2 ½” Clamp onto the Muffler outlet. Install the Over Axle
Pipe to the Muffler install the Over Axle Pipe hanger into the factory
rubber insulator. Refer to Figure 7.
4. Slide a 2 ½” Clamp onto the Over Axle Pipe and install the Tail
Pipe. Slide the Tail Pipe hanger into the existing the rubber insulator.
Refer to Figure 8.
5. Align the exhaust as required. Starting at the front of the exhaust,
tighten all clamps and connections.
6. Reinstall the guard below the transfer case.
7. Check along the whole length of the exhaust system to ensure that
there is adequate clearance around the spare tire, fuel and brake lines or
any wiring. If any interference is detected relocate or adjust.
Congratulations! You are ready to begin experiencing the improved
power, sound and driving experience of your MBRP Inc. performance
exhaust system. We hope you enjoy your purchase.
Figure 5
Figure 6
Figure 7
Figure 8