MBRP S8201 - Manual (Page 4)

S8201 © 05/10 PAGE 4 OF 4
10. Set the T-Pipe Assembly at the desired height from the floor of the
bed (This will set the height of the Stacks). Using spacers to hold the
T-Pipe Assembly at the desired height, loosely attach the Stacks to
the Mounting Brackets making sure that they are straight. This will
hold the assembly steady while you line up to the exhaust underneath
the vehicle. Refer to Figure 7.
11. Measure from the T-Pipe slip joint to the Extension Pipe. Mark and
cut the shorter side of the 14” Elbow to the required length so that it
lines up with the front part of the exhaust system. Refer to Figure 8.
12. Attach the 14” Elbow to the T-Pipe slip joint and then attach the Flex
Pipe to both the 14” Elbow and the Extension Pipe. Be sure the
slide the required Clamps over the 14” Elbow and Flex Pipe before
connecting it to the vehicle’s exhaust system. Refer to Figure 9.
13. Make sure that the Mounting Brackets are centered on the Stacks
and tighten the fasteners holding the Mounting Brackets to the front
of the truck bed. Tighten all Clamps making sure that the Stacks
remain properly aligned.
Shown with 6”x36” Stacks (B1610) and Cover (BB0003)
Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of
your MBRP Inc.
“Smokers
TM
”.
We are certain that you will enjoy your purchase.
Figure 7
Figure 8
Figure 9