Smokers – MBRP S8006 User Manual

Page 4

S8006 © 11/09

PAGE 4 OF 4

9. Measure from the Extension Pipe slip joint to the Mid Pipe. Mark and cut

the shorter side of the Elbow to the required length so that it lines up with
the Mid Pipe. Cut the vehicle’s exhaust system in a place where the Flex
Pipe can be placed between the Mid Pipe and the Elbow. It may be
necessary to cut the Elbow again as well as cut the Flex Pipe to ensure
proper fit. Refer to Figure 9.

10. Attach the Elbow to the Extension Pipe slip joint and then attach the Flex

Pipe to both the Elbow and the Mid Pipe. Be sure to slide the required
Clamps over the Elbow and Flex Pipe before connecting it to the Mid
Pipe. Refer to Figure 10.

11. Slide the Bed Mounting Bracket onto the Extension Pipe. Install the

assembly on the outlet of the Elbow with the required Clamp. Reinstall the
Stack by sliding the inlet over the Extension Pipe and then securing the
Stack to the Stack Mounting Bracket with the Clamp supplied with your
Stack. Align the system and tighten all Clamps to ensure that your

“Smokers

””””

exhaust remains properly aligned.

12. Slide the Bed Mounting Bracket to the desired position on the Extension Pipe to allow installation of the mounting

hardware. Ensure the Stack is vertical. Trace the Bed Mounting Bracket hole from the bracket onto the bed floor
and drill a hole to accommodate the 3/8” hardware supplied. Secure the Bed Mounting Bracket to the truck and
tighten the Clamp to the Extension Pipe. This Bed Mounting Bracket will ensure the Stack remains in position and
doesn’t vibrate.

13. Check along the whole length of the exhaust system to ensure that there is adequate clearance around the fuel lines,

brake lines and any wiring. If any interference is detected relocate or adjust.

Shown with 6” x 36” Stack (B1610)

Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of your

MBRP Inc.

“Smokers

””””

. We know you will enjoy your purchase.

Figure 9

Figure 10