MBRP S8200 - Manual (Page 2)

Installing Your Front Section of MBRPinc.
“Smokers™”
:
1 PC - Down Pipe
1 PC - Extension Pipe
1 PC - 4" Clamp
Removal of Stock System:
1. Loosen the nut on the band clamp located behind the catalytic converter using a 15mm wrench or socket.
2. If a hoist is being used for the installation, the original exhaust system can be removed in one piece by
removing the passenger side shock. If a hoist is not being used the tail pipe must be cut behind the muffler to be
removed.
3. Remove the muffler and tail pipe from the OEM rubber hangers and separate the stock exhaust at the slip joint
located behind the catalytic converter and remove the muffler and tail pipe from under the truck. Re-install the
passenger side shock.
4. Remove the catalytic converter by removing the two nuts holding the inlet flange together using a 15mm
wrench or socket.
5. Remove the down pipe from the turbo by removing the band clamp using an 11mm socket. Retain the band
clamp for the installation of the new down pipe. Cut the down pipe in front of the transmission cross member
to remove. (Note: The stock down pipe can be removed in one piece by removing the transmission cross
member. It is recommended that this only be done by qualified, trained professionals using tools and equipment
designed to safely carry out this procedure.)
Installing Your Front Section of MBRPinc.
Smokers™”
:
1. Install the Down Pipe in the same position as the stock down pipe and attach the flared end to the turbo using
the stock band clamp. Do not fully tighten until all components are in place.
2. Loosely attach the Extension Pipe to the Down Pipe and place the hanger into the factory rubber insulator
located on the frame. The Extension Pipe may need to be trimmed to mate up to the rear section of the
“Smokers™”
.
S8200 © 03/06 Page 2 of 5