MBRP S8114 - Manual (Page 4)

S8114 © 11/09 PAGE 4 OF 4
10. Slide the Bed Mounting Bracket onto the 18” Extension Pipe. Install the assembly on the outlet of the
20” Elbow with the required Clamp. Reinstall the Stack by sliding the inlet over the 18” Extension Pipe
and then securing the Stack to the Mounting Bracket with the Clamp supplied with your Stack. Align the
system and tighten all Clamps to ensure that your
“Smokers “Smokers “Smokers “Smokers
TM TM TM TM
”””” exhaust system remains properly aligned.
11. Slide the Bed Mounting Bracket to the desired position on the 18” Extension Pipe to allow installation of
the mounting hardware. Ensure the Stack is vertical. Trace the Bed Mounting Bracket hole from the
bracket to the bed floor and drill a hole to accommodate the 3/8” hardware supplied. Secure the Bed
Mounting Bracket to the truck and tighten the Clamp to the 18” Extension Pipe. This Clamp will ensure
the Stack remains in position and doesn’t vibrate.
12. Check along the whole length of the exhaust system to ensure that there is adequate clearance around fuel
lines, brake lines and any wiring. If any interference is detected, relocate or adjust.
Congratulations! You are ready to begin experiencing the improved power, sound and driving excitement of
your MBRP Inc.
““““Smokers Smokers Smokers Smokers
TM TM TM TM
”””” .
We are certain that you will enjoy your purchase.