MBRP S8000 - Manual (Page 5)

8. Measure from the “T” Pipe slip joint to the exhaust system that you are
connecting to. Mark and cut the shorter side of the Elbow to the required length
so that it lines up with the front part of the exhaust system. Refer to figure 6.
9. Loosely install the Elbow into the “T” Pipe. Measure and mark the Elbow,
Extension Pipe and Flex Pipe so that you will end up with the longest section of
Flex Pipe possible. Cut the pieces to the required lengths.
10. Attach the Elbow to the “T” Pipe slip joint and then attach the Flex Pipe to
Figure 6 both the Elbow and the front part of the exhaust system. Be sure to slide the
required Clamps over the Elbow and Flex Pipe before connecting it to the vehicle’s exhaust system.
11. Make sure that the Mounting Brackets are centered on the Stacks and tighten the fasteners holding the
Mounting Brackets to the front of the truck bed. Tighten all the Clamps making sure that the
“Smokers™”
remains properly aligned.
12. Install remaining clamps around pipes where required. Check along the whole length of the exhaust system to
ensure that there is adequate clearance around the fuel and brake lines or any wiring. If any interference is
detected relocate or adjust.
Shown with 5” X 36” Angle Cut Stacks (B1530)
Congratulations! You are ready to begin enjoying the improved performance and driving experience of your
MBRP Inc.
“Smokers™”
. We hope you enjoy your purchase.
S8000 © 03/06
Page 5 of 5