MBRP S6250 - Manual (Page 3)

S6250 © 09/10 PAGE 3 OF 3
6. Place the rubber isolator of the Hanger Kit onto the hanger on the LHS
Over-Axle/Tail Pipe.
7. Install the LHS Over-Axle/Tail Pipe to the Y-Pipe and fasten the
Hanger Kit to the vehicle frame using the hardware provided. Refer to
Figures 6 & 7 for the correct mounting hole location. Hand-tighten a 4”
Clamp at the Y-Pipe connection point.
8. Install an Exhaust Tip on each side using a 17mm wrench.
Refer to Figure 8.
9. Align the exhaust as required and fully-tighten all clamps.
10. Ensure that there is adequate clearance around the spare tire or any fuel
and brake lines.
Congratulations! You are ready to begin experiencing the improved
power, sound, and driving experience of your MBRP Inc. performance
exhaust system. We know you will enjoy your purchase.
Figure 6
Figure 7
Figure 8