MBRP S6248SLM - Manual

Removal of stock system:
1.
Apply a penetrating lubricant liberally to all exhaust fasteners, hangers and rubber insulators.
2.
Loosen the three (3) nuts securing the extension pipe flange to the over-axle pipe
3.
Remove the factory over-axle/tail pipe.
4.
Loosen the three (3) nuts securing the extension pipe to the flange directly behind the exhaust filter and remove the extension
pipe.
Installation of MBRP Inc. Performance Exhaust:
1.
The Extension Pipe is pre-cut for the 172.4” (crew-
cab long-box) wheelbase. Cut the Extension Pipe
to the appropriate length for the installation vehicle.
2.
Mate the Extension Pipe flange to the stock
exhaust flange with the Flange Gasket between
them and fasten the flanges together with the
hardware provided.
3.
Fit the Hanger Clamp loosely over the end of the extension pipe and insert the hangers into the rubber isolators.
4.
Install the Over-Axle/Tail Pipe onto the Extension Pipe, inserting the hanger into the rearward factory rubber isolator.
5.
Install the Louvered Tail Section onto the Over-Axle/Tail Pipe and secure it with the 4” Clamp provided.
6.
Align the exhaust as required and tighten all connections.
7.
Ensure that there is adequate clearance around the spare tire or any fuel and brake lines.
Congratulations! You are ready to begin experiencing the improved performance and driving excitement of your MBRP Inc.
performance exhaust system. We know you will enjoy your purchase.