MBRP S6224TD - Manual (Page 3)

S6224TD
3 of 3
6. Install the Hanger Clamp into the two OEM rubber hangers located above the outlet of the Muffler.
7. Install the Tail Pipe from the rear of the truck, over the axle and attach to the outlet of the Muffler.
8. Install the provided clamps around pipes where needed. Adjust the Tail Pipe and check along the whole length
of the exhaust system to ensure there is adequate clearance around the fuel and brake lines or any wiring. If any
interference is detected relocate and adjust.
9. Make sure exhaust is in place before tightening clamps. Start at the front of the exhaust system and begin
tightening all connections.
10. Using a 17mm wrench tighten lock bolt located on the Tip.
Congratulations! You are ready to begin enjoying the improved performance and driving experience of your MBRP
Inc. performance exhaust system. We know you will enjoy your purchase.