MBRP S6036 - Manual (Page 3)

S6036 © 11/10 PAGE 3 OF 3
2. Use the 5” Hanger Clamp to install the Tail Pipe to the Extension Pipe.
Refer to Figure 6.
3. Install the Tail Pipe hanger into the factory rubber insulator.
Refer to Figures 7.
4. Align the Tail Pipe and tighten Clamps starting at the front and working
rearward to secure the system.
5. Check along the full length of the exhaust system to ensure there is adequate
clearance for fuel lines, break lines, and any wiring, etc. If any interference
is detected, relocate or adjust to provide adequate clearance.
Congratulations! You are ready to begin experiencing the improved
performance and driving pleasure of your MBRP Inc. performance exhaust
system. We know you will enjoy your purchase.
Figure 6
Figure 7
Figure 8