MBRP S6022 - Manual (Page 3)

10. Install the provided clamps around the pipes where needed. Adjust the Tail Pipe and check along
the whole length of the exhaust system to ensure that there is adequate clearance around the fuel
and brake lines or any wiring. If any interference is detected relocate or adjust.
11.
Make sure the exhaust is in place before tightening the clamps. Start at the front of the exhaust
system and begin tightening all connections.
12. If a tip has been purchased, install and adjust to suit. Using a 17mm wrench tighten the lock bolt
located on the Tip. A Tip is not included with this kit. Tips may be purchased separately, check
with your dealer.
Congratulations! You are ready to begin enjoying the improved performance and driving experience of
your MBRP Inc. performance exhaust system. We hope you enjoy your purchase.
S6022 © 08/08 Page 3 of 3