MBRP S6212TD - Manual (Page 3)

S6212TD © 11/10 PAGE 3 OF 3
3. Attach the 42" Extension Pipe to the Mid Pipe. For Extended Cab Short
Bed vehicles this is the only Extension Pipe required. For Crew Cab Long
Bed vehicles you will require the full length of both the 32" Extension
Pipe and the 42" Extension Pipe. For Extended Cab Long Bed and Crew
Cab Short Bed vehicles the 32" Extension Pipe will have to be cut. For
Extended Cab Long Bed vehicles, attach the two extension pipes and cut
the 32" Extension Pipe to a combined, attached length of 57 1/4". For
Crew Cab Short Bed vehicles attach the two extension pipes and cut the
32" Extension Pipe to a combined, attached length of 55 1/4".
Refer to Figure 6.
4. Install the Muffler over the Extension Pipe. The Hanger Clamp is used at
the connection between the Muffler and the Extension Pipe and installed
into the OEM rubber hanger at this position. Install the “T” Hanger
Clamp into the two OEM rubber hangers located above the outlet of the
Muffler. Refer to Figure 7 & 8.
5. Install the Tail Pipe from the rear of the truck, over the axle and attach to
the Muffler Outlet. Adjust for best axle clearance and Tail Pipe exit
location to complete. Refer to Figure 9.
6. Install and adjust the Exhaust Tip to suit. Using a 17mm wrench tighten
the bolt located on the Exhaust Tip.
7. Install the provided clamps around the pipes where needed. Check along
the whole length of the exhaust system to ensure that there is adequate
clearance around the fuel and brake lines or any wiring. If any interference
is detected relocate or adjust.
Congratulations! You are ready to begin experiencing the improved power,
sound and driving excitement of your MBRP Inc. performance exhaust system.
We know you will enjoy your purchase.
Figure 6
Figure 7
Figure 8
Figure 9