MBRP S6200TD - Manual (Page 3)

S6200TD © 11/10 3 of 3
3. Install the Muffler over the Extension Pipe or over the Mid Pipe with 137"
wheelbase vehicles. Refer to the figure on the left for correct Muffler
orientation.
4. Install the Tail Pipe from the rear of the truck, over the axle and attach to the
outlet of the Muffler. Install the tail pipe hanger into the OEM hanger to
complete.
5. Install the T-Hanger Clamp into the two OEM rubber hangers located above the outlet of the Muffler.
6. Install the provided Clamps around the pipes where required. Adjust the Tail Pipe and check along the
whole length of the exhaust system to ensure that there is adequate clearance around the fuel and brake
lines or any wiring. If any interference is detected relocate or adjust.
7. Ensure that the exhaust is in place before tightening clamps. Start at the front of the exhaust system and
begin tightening all connections.
8. Install and adjust the Exhaust Tip to suit. Using a 17mm wrench tighten lock bolt located on the Exhaust
Tip.
Congratulations! You are ready to begin experiencing the improved driving pleasure of your MBRP Inc.
performance exhaust system. We know you will enjoy your purchase.