MBRP S6052 - Manual (Page 3)

S6152 © 02/13 PAGE 3 OF 4
Installation of MBRP Down Pipe
1. Feed the MBRP Down Pipe into area between the transmission and the frame.
2. Insert the Down Pipe into the exhaust housing of the turbo completely until
the flange on the turbo and Down Pipe are flush.
3. Loosely fit the stock band clamp on the upper turbo and down pipe connection
to keep the Down Pipe from falling out but allowing it to rotate slightly.
Refer to Figure 7.
4. Reinstall the transmission dipstick into the transmission and the two nuts to
the back of the bell housing.
5. Secure the Down Pipe to the bracket on the exhaust manifold using the
original bolt.
Reinstall the front pipe to the rear exhaust.
6. Reinstall the band clamp securing the front pipe to the Down Pipe.
Refer to Figure 8.
7. Tighten the upper band clamp securing the Down Pipe to the turbo housing.
8. Replace the upper heat shield and secure it using the original bolts and
reinstall the electronic module if needed.
9. Start the vehicle to check for exhaust leaks.
10. Reinstall the inner fender liner and wheel.
Removal of Stock System
1. Apply a penetrating lubricant liberally to all exhaust fasteners, hangers
and rubber isolators.
2. Cut the factory tail pipe as shown and remove the rear section. Remove
the factory tail pipe assembly from the factory rubber isolators.
Refer to Figure 9.
3. Remove the three nuts at the muffler inlet flange and remove the
muffler. Refer to Figure 10.
Figure 6
Figure 7
Figure 8
Figure 9
Figure 10