MBRP S6218 - Manual (Page 3)

7. Install the Tail Pipe from the rear of the truck, over the axle and attach to the Muffler outlet. Install
the tail pipe hanger into the OEM hanger to complete.
8. Adjust the Tail Pipe and check along the whole length of the exhaust system to ensure that there is
adequate clearance around the spare tire, fuel and brake lines or any wiring. If any interference is
detected relocate or adjust.
9. Make sure the exhaust is in place before tightening clamps. Start at the front of the exhaust system
and begin tightening all connections.
10. Install and adjust Tip to suit. Using a 17mm wrench tighten lock bolt located on Tip.
Congratulations! You are ready to begin enjoying the improved performance and driving experience of
your MBRP Inc. Performance Diesel Exhaust system. We hope you enjoy your purchase.
s
6218 © 10/11 Page 3 of 3