MBRP S6030 - Manual (Page 2)

S6030 © 04/10 PAGE 2 OF 4
Removal of stock system:
1. Apply a penetrating lubricant liberally to all exhaust fasteners,
hangers and rubber isolators.
2. Remove the factory tail pipe assembly from the factory rubber
isolators. Refer to Figures 1 and 2.
3. Cut the factory tail pipe as shown and remove the rear section.
Refer to Figure 3.
4. Remove the three nuts at the muffler inlet flange and remove
the muffler. Refer to Figure 4.
Figure 1
Figure 2
Figure 3
Figure 4