beautypg.com

MBRP S6026 User Manual

Page 3

background image

S6026 © 02/13

PAGE 3 OF 4



Installation of MBRP Inc. Performance Exhaust

1. Install the three supplied 7/16” Bolts in the existing flange and
place the supplied Gasket over the bolts. Refer to Figure 5.

2. Install the Extension Pipe onto the flange. There is a slight bend in the
Extension Pipe. The inside of this bend must face the driveshaft. If the
outlet of the Extension Pipe angles slightly towards the driveshaft you have
installed it correctly. Failure to install this pipe correctly will result in the
Tail Pipe not fitting properly. Secure with the three supplied 7/16” Flat
Washers
, three 7/16” Lock Washers and three 7/16” Nuts. Refer to
Figure 6.


3. Slide the 4” Clamp over the outlet of the Extension Pipe. Install the
Tail Pipe from the rear of the truck over the axle and slide on to the
Extension Pipe. Install the Tail Pipe hangers into the factory rubber
isolators. Refer to Figures 7 and 8.

4. Loosely install the supplied Tip and align the Tail Pipe approximately
horizontal as viewed from the rear of the truck. Once the system is
aligned, tighten the previously installed 4” Clamp and secure the Tip by
tightening the bolt with a 17mm wrench. Refer to Figure 9.

9. Check along the whole length of the exhaust system to ensure that
there is adequate clearance around the spare tire, fuel and brake lines or
any wiring. If any interference is detected relocate or adjust.



Figure 5

Figure 6

Figure 7

Figure 8


Figure 9