MBRP S6246AL - Manual (Page 3)

S6246 © 02/13 PAGE 3 OF 3
2. Slide the 3.5” Band Clamp over the Extension Pipe and install
to the particulate filter. Refer to Figure 4.
3. Slide the 5” Band Clamp onto the end of the Extension Pipe.
Install the Tail Pipe onto the Extension Pipe. Install the Tail Pipe
hangers into the OEM rubber insulators. The clamp should remain
loose enough for adjustability. Refer to Figure 5.
4. Align the exhaust as required. Starting at the front of the exhaust,
tighten all clamps and connections.
5. Check along the whole length of the exhaust system to ensure
that there is adequate clearance around the spare tire, fuel and brake
lines or any wiring. If any interference is detected relocate or adjust.
Congratulations! You are ready to begin experiencing the improved power, sound and driving experience
of your MBRP Inc. performance exhaust system. We hope you enjoy your purchase.
(Note: Ask your dealer about our selection of optional tips or visit us at www.mbrp.com.)
Figure 4
Figure 5