MBRP S6216 - Manual (Page 3)

S6216 © 07/11 3 OF 4
3. Attach the factory catalytic converter to the Mid Pipe by placing the gasket
supplied between the flanges and installing the two nuts that were removed
previously. See Figure 6.
Figure 6
4. Install the Extension Pipe over the catalytic converter. See Figure 7.
Figure 7
5. Install the Muffler over the Extension Pipe. The
Hanger Clamp is used at the connection between
the Muffler and the Extension Pipe and installed
into the OEM rubber hanger at this position. Install
the “T” Hanger Clamp into the two OEM rubber
hangers located above the outlet of the Muffler.
See Figure 8.
Figure 8
6. Install the Tail Pipe from the rear of the truck, over the axle and attach to
the Muffler Outlet. Install the tail pipe hanger into the OEM hanger, and
then adjust for best axle clearance and Tail Pipe exit location to complete.
See Figure 9.
Figure 9
7. Install the provided clamps around the pipes where needed. Adjust the Tail Pipe and check along the
whole length of the exhaust system to ensure that there is adequate clearance around the fuel and brake
lines or any wiring. If any interference is detected relocate or adjust.
8. Make sure the exhaust is in place before tightening the clamps. Start at the front of the exhaust system
and begin tightening all connections.