MBRP S6120 User Manual
Page 3

S6120 © 04/10
PAGE 3 OF 3
2. Slide the 4” Hanger Clamp onto the end of the Extension Pipe.
Install the hangers into the existing OEM rubber insulators.
Refer to Figure 5.
3. Install the Tail Pipe from the rear of the truck, over the axle and attach
to the Extension Pipe using the 4” Hanger Clamp. Slide the Tail Pipe
hanger into the OEM rubber insulator. Refer to Figure 6.
4. Install and adjust the Extension Tip to suit. Using a 17mm wrench,
tighten the lock bolt located on the Exhaust Tip. Refer to Figure 7.
5. Align the exhaust as required. Starting at the front of the exhaust,
tighten all clamps and connections.
6. Check along the whole length of the exhaust system to ensure that
there is adequate clearance around the spare tire, fuel and brake lines or
any wiring. If any interference is detected relocate or adjust.
Congratulations! You are ready to begin experiencing the improved power, sound and driving experience of
your MBRP Inc. performance exhaust system. We are certain that you will enjoy your purchase.
Figure 5
Figure 6
Figure 7