MBRP S6020 User Manual
Page 3
8.
Install the Tail Pipe from the rear of the truck, over the axle and attach to the Muffler outlet. To
complete install the tail pipe hanger into the OEM hanger and adjust for best axle clearance and Tail
Pipe exit location.
9.
Install the Hanger Clamp into the OEM rubber hanger located above the outlet of the Muffler.
10. Install provided clamps around pipes where needed. Adjust Tail Pipe and check along the whole
length of the exhaust system to ensure there is adequate clearance around the fuel and brake lines or
any wiring. If any interference is detected relocate or adjust.
11. Make sure exhaust is in place before tightening clamps. Start at the front of the exhaust system and
begin tightening all connections.
12. If a tip has been purchased, install and adjust to suit. Using a 17mm wrench tighten lock bolt located on
Tip. A Tip is not included with this kit. Tips may be purchased separately, check with your dealer.
Congratulations! You are ready to begin enjoying the improved performance and driving experience of
your MBRP Inc. performance exhaust system. We hope you enjoy your purchase.
S6020 © 01/09
Page 3 of 3