beautypg.com

Mbrp inc – MBRP S6244 User Manual

Page 2

background image

S6244 © 02/13

PAGE 2 OF 3



Removal of Stock System:

1. Apply penetrating lubricant liberally to all exhaust fasteners,

hangers and rubber insulators.

2. Loosen the nut on the band clamp located behind the particulate

filter using a 15mm wrench or socket. Refer to Figure 1.

3. Remove the muffler and tail pipe from the OEM rubber hangers.

Cut exhaust as shown in Figure 2. Remove from vehicle.

Installation of

MBRP Inc

.

Performance Exhaust:

1. Install the Adaptor over the particulate filter using the

3.5”

Clamp. Leave the clamp loose until final alignment. Refer
to Figure 3
.

2. The Extension Pipe provided is pre-cut for the crew cab

long bed configuration. Cut the Extension Pipe to length as
required. See Figure 5. The Extension Pipe is not required
on a super cab short box (6.5’). Slide a 4” Clamp over the
Extension Pipe and install onto the Adaptor installed in
Step 1. The clamp should remain loose enough for
adjustability. Refer to Figure 4.






Figure 1

Figure 2

Figure 3

Figure 4

Figure 5