Manley JUNIOR DAC 1995 - 2000 - Manual (Page 4)

MAINS CONNECTIONS
Your unit has been factory set to the correct mains voltage for your country. The
voltage setting is marked on the serial badge, located on the rear panel. Check
that this complies with your local supply.
Export units for certain markets have a moulded mains plug fitted to comply with
local requirements. If your unit does not have a plug fitted the coloured wires
should be connected to the appropriate plug terminals in accordance with the
following code.
GREEN/YELLOW EARTH terminal
BLUE NEUTRAL terminal
BROWN LIVE terminal
As the colours of the wires in the mains lead may not correspond with the coloured
marking identifying the terminals in your plug proceed as follows;
The wire which is coloured GREEN/YELLOW must be connected to the terminal in
the plug which is marked by the letter E or by the safety earth symbol or coloured
GREEN or GREEN and YELLOW.
The wire which is coloured BLUE must be connected to the terminal in the plug
which is marked by the letter N or coloured BLACK.
The wire which is coloured BROWN must be connected to the terminal in the plug
which is marked by the letter L or coloured RED.
DO NOT CONNECT/SWITCH ON THE MAINS SUPPLY UNTIL ALL OTHER
CONNECTIONS HAVE BEEN MADE.