Manley DIGITAL TO ANALOGUE CONVERTER 1990 - 1997 - Manual (Page 4)

S/PDIF
S/PDIF S/PDIF
AES
AES AES
UNBAL IN
BAL IN
UNBAL IN BAL IN
-20 LO-Z LEFT
RIGHT
REAR PANEL
A IEC MAINS SOCKET: Standard IEC mains socket (120/240 VAC)
B FUSE HOLDERS: Replace with 1A SLO-BLO fuse only.
C VOLTAGE CHANGEOVER SWITCH: Set for the correct mains voltage for
your area by rotating the centre section with a flat screwdriver.
D S/PDIF DIGITAL OUTPUTS: These two Sony-Phillips Digital Interface
unbalanced digital outputs appear on UHF style jacks. BNC or RCA to UHF
adaptors are easily available if you prefer to use BNC or RCA terminated cables,
however, we believe the UHF connector is the most robust and well shielded
connector for coaxial digital links.
E S/PDIF / AES SELECT: This LOCKING switch will optimise either AES or
SPDIF digital formats. To change the setting of this switch, PULL OUT the
toggle before switching! The MANLEY A TO D CONVERTER is standardly
shipped with two AES plus two SPDIF outputs, although any combination may
be specially ordered.
F AES DIGITAL OUTPUTS: These two AES balanced digital outputs appear on
3-pin XLR jacks. The pinout is as follows: PIN 1 GROUND
PIN 2 HOT
PIN 3 LOW
A B C D E F G H I J K
G UNBALANCED / BALANCED INPUT SELECT: This switch will select either
the unbalanced inputs OR the electronically balanced inputs. Be sure the correct
input is selected here.