Manley ELOP - Manual (Page 13)

SPECIFICATIONS
ALL-TUBE audio path 12AU7WA + 6414 per ch.
Unbalanced 1/4” Inputs And Outputs and...
Balanced Transformer Coupled XLR Inputs And Outputs
Hi-current drive <50 ohm 1/4” & XLR outputs
Silent conductive plastic INPUT attenuators
Max. GAIN REDUCTION 22dB
ATTACK time: 10mS for 6dB GR
RELEASE: 2.5 Seconds for 6dB GR
Maximum Input (Bypass through Line Amplifier) +30 dBv (with Limit “IN” the maximum is entirely variable)
Maximum Output +30 dBv
Headroom (referenced to +4 dBv) 26 dB
Frequency Response: 10 Hz to 70 kHz +/- 0.5 dB
BYPASS switches and AUTOMUTE w/warmup delay
Large ILLUMINATED Sifam VU METERS (older units before serial number MELOP®B716 shipped before 6/2003 use: 26V
1.2W FESTOON LAMPS; Manley’s Part Number: VAR016B) Order spare bulbs using our parts order form. (newest units
after serial number MELOP®B716 shipped after 6/2003 use yellow LED lighting)
Meters switch to read OUTPUT or REDUCTION
STEREO LINK
Side-Chain High-Pass Filter 100Hz or 200Hz
THD & Noise (1kHz @ +4 dBm): .015%
Noise Floor (Gain set to minimum): -80 dB Wideband
Signal to Noise Ratio: 126 dB typical
Maximum gain: 15 dB
Power consumption: 40 watts
Operating mains voltage: Units are purpose built for original destination country’s mains voltage: 100V, 120V, or 220-240VAC
as indicated on the serial number badge. Power transformer must be replaced in order to change mains operating voltage.
120VAC units may NOT be rewired to put the primaries of the power transformer in series for 220-240V operation or a large
radiated field of hum will develop. If changing locations/voltages, the power transformer must be replaced with the dedicated
one for the voltage at which it will operate.
Mains Voltage Frequency: 50~ 60Hz
Dimensions: 19” x 3 1/2” x 10” (occupies 2u)
Shipping weight: 16 lbs.
13