King of Fans Cressner - Manual (Page 11)

Attaching the Light
Kit/Glass Bowl
CAUTION- To reduce the risk of
electrical shock, disconnect the
electrical supply circuit to the fan
before installing light kit.
THE GLASS IS FRAGILE, USE
CARE WHEN INSTALLING THE
LIGHT KIT AND THE GLASS
SHADE.
1. Remove one of three mounting
screws and lockwashers in the light kit
plate and loosen the other two mounting
screws and lockwashers.
2. Connect the 9-position molded
adaptor plug
exiting the fan motor
assembly with the adaptor plug exiting
the light kit (Figure 13).
3.
Align the two key slots in the light
kit with the two mounting screws and
lockwashers in the light kit plate and
place the light kit over two screws, turn
the light kit clockwise until it locks,
tighten the two mounting screws
and
lockwashers .
4. Re-install the mounting screw and
lockwashers that was removed in step 1
and tighten firmly.
5. With the power off, insert the light
bulbs into the light kit sockets (Max.
40W provided).
6.
Pass the light switch chain through
the center hole in the glass bowl and
then through the hole in the finial
(Figure 14). Pass the fan switch through
the side hole in the glass bowl.
7.
Position the glass bowl over the
threaded tube of the light kit and finger
tight with finial.
8.
Install the fobs provided to the light
switch chain and fan switch chain.
8.