HUACAM HCV725 User Manual
Page 10
www.huacam.com 10
5. Double click the column of the detected camera, the browser will automatically open and link to
the device IP and the web configuration page.
6. The browser will ask for plug-in or ActiveX if not installed, otherwise it will get to Home page
and start to show the video captured by the camera (by default the camera enabled anonymous
access)
7. Click “Configuration”, the browser will ask credentials to authorize configuration.
8. Enter the administrator user name and password to access the Web Configuration Interface,
the default user name and password are both set to admin.
9. In step 6, IE will indicate that “This website wants to install the following add-on:
HCViewerX.cab from Huacam Networks Inc.”, allow the installation.
10. Firefox user need to download and install the plug-in to see the video, the plug-in for Firefox
is here:
http://www.huacam.com/index.php?option=com_jdownloads&Itemid=103&view=finish&cid=5&cat
id=1
NOTE:
Please temporarily disable Antivirus or Internet Security Software when download and install
the Huacam Firefox plug-in for video or “HCViewerX.cab” for Microsoft Internet Explorer.
Connect to the Camera using Static IP
If no DHCP server in the network, or the camera does not get IP from DHCP server, user can
connect the camera to a computer directly, using static IP to configure the camera.
The default IP, if no DHCP server; or DHCP offer time out (3 minutes), is 192.168.1.168
1. Connect the computer RJ-45 via an Ethernet cable directly to the IP camera HCV725 .
2. Configure the computer using Static IP: 192.168.1.XXX (1 configure the “Subnet mask” to “255.255.255.0”. Leave the “Default Gateway” to “Blank” like below: