Fantasea Line Nano Focus Light User Manual

Page 2

Fantasea Nano Focus Light Instruction Manual 20110120

Identification of Nano Focus Light Parts

LED Torch Head

Y‐S Connector

Hand Lanyard

Dim‐Out Sensor

Instructions for Use

A. Installing & Removing Batteries

a. To open the Nano Focus Light, hold the hand grip firmly in one hand and

turn the flashlight head counterclockwise until it separates. Pull the
flashlight head off. Please make sure that the light is pointed in an upward
position so the contents do not fall out when opened. Take special care not
to stare into the light beam which is very powerful and could damage your
eyes.

b. Gently remove the LED head by pulling it out.
c. Install or remove 4 AAA Alkaline batteries. Please note that this light should

not be used with rechargeable batteries. Make sure to follow the
instructions diagram printed on the interior of the light. Note that there are
two sets of two batteries, each set pointing towards a different direction.

d. Replace the LED head carefully, making sure that the two protrusions on the

inside of the battery compartment correspond with the two niches on the
LED head. This is the only way it will fit properly.

e. Carefully place the flashlight head over the threads, and tighten evenly in a

clockwise fashion. Do not use force and do not allow it to screw down
unevenly. Take special care not to stare into the light beam which is very
powerful and could damage your eyes.