FanAm GreenLine Inline Series (plastic) - Manual (Page 2)

Installation
Electrical Supply
Check that the voltage and circuit details on the fan are
suitable for your supply.
Caution: Never work on a fan unless power is turned
off.
Wiring
All wiring should be carried out in compliance with
regulations for electrical installations and comply with
any local requirements.
Caution: Never work on a fan unless power is turned
off.
Starting
All fans are suitable for direct starting by switch or direct
line starter. All fans may be directly controlled by
thermostat or similar devices, provided that the current
rating is at least three times the motor rating.
Protection
All fan blowers are provided with Thermal Overload
Protection internally. In the event that the fan
overheats, the T.O.P. will break the circuit until the fan
returns to normal operating temperature.
Caution: Never work on a fan unless power is turned
off.
Rotating
The direction of rotation, looking into the hub of the
blower, is clockwise.
Mounting (See images to the right)
All fans are suitable for mounting in any plane.
Attach the black plastic mounting bracket to the support
frame where you wish to mount the fan. Slide in the
metal bracket (attached to the fan) into the already
mounted black plastic bracket until you hear a light
clicking sound.
Operation
All fans are suitable for internal or external use. When
used externally, sealing around the casing joint is
recommended. The blower is designed to operate in a
temperature range of -25F to +175F and up to 95%
Relative Humidity.
Ductwork Connection
Flexible ducting should be clamped to the unit by using
screw tensioned connector clips or duct tape. Rigid
ducting should be connected with a flexible connector
and screw tensioned clip or insulated fast clamp.