beautypg.com

Cloyes Hex-A-Just (4.6 Ford Modular SOHC) User Manual

Installation instructions, Stop: read all instructions before installation

background image

© Copyright 2008, Cloyes Gear Company. All rights reserved.

1

INSTALLATION INSTRUCTIONS

FORD 4.6L MODULAR SOHC ENGINES

9-3162A, 9-3163A, 9-3164A, 9-3165A, 9-3166A, 9-3169A, S764HAJ, S766HAJ

STOP: Read all instructions before installation.


Note:

These instructions pertain to the adjustable sprockets only. For the step by step instructions to replace
the timing set refer to a Ford 4.6L shop manual. Although the degree wheel method is strongly
recommended, the process is not covered in these instructions. Installation is suggested to be
performed by a shop familiar with the Ford Modular engine.

Tools Needed:

1. Shop Manual
2. 5/32 in. Hex Wrench
3. ½ in. Wrench
4. Torque Wrench
5. Degree Wheel & Necessary Cam Timing Accessories


Supplies Needed:

1. Thread Locking Compound
2. Pre-Lube for chain & sprockets



Step 1: Prepare Engine

As per Shop Manual disassemble to allow
removal of the original timing components.
DISCARD THE OEM CAM BOLT
WASHERS; THEY ARE NOT
REQUIRED WITH THIS SET.



Step 2: Prepare Parts

Before assembly clean all parts and mating
surfaces.


Step 3A: Adjust and set timing - FOLLOW
STEP IF NOT USING A DEGREE
WHEEL

Before mounting the two cam sprockets on
the engine, use a 5/32” hex wrench to loosen


Adjuster Plate

Button Screws

Sprocket

Figure 1

Figure 2