Ariston AW 149 - Manual (Page 9)

NA
9
www.aristonappliances.us
Electrical connection
Machine Voltage/Amperage - 120V, 60 Hz, 11 Amp.
Connection - 3-prong plug with 6’ cord is provided
with the machine.
Circuit/Protector - 3-wire single phase, 120V, 60 Hz, AC,
on a separate 15 Amp circuit.
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of malfunction,
or beakdown, grounding will reduce the risk of electric shock
by providing a path for electric current. This appliance is
equipped with a cord having an equipment grounding
conductor and grounding plug. Plug into an appropriate outlet
that is properly installed and grounded in accordance with all
local codes and ordances. DO NOT modify the plug provided
with the applliance. If it will not fit the outlet, have a proper
outlet installed by a qualified electrician.
WARNING: Improper connection of the equipment-grounding
conductor can result in a risk of electric shock.
Check with a qualified electrician or serviceman if
you are in doubt as to whether the appliance is
properly grounded.
Attention !
For your own protection and to prevent accidents, injury
and fire, please read the following carefully before
installing the washer.
• Installation and grounding must be done in accordan-
ce with local codes and by a qualified installer.
Instalation instructions provided in this booklet are for
the installer’s reference.
• Washer MUST be installed on a strong, level floor and
in a protected dry and well-ventilated area close to a
power supply and drain outlet of sufficient capacity.
DO NOT install on carpet.
Important :
Installation on carpet floors will cause the machine to
vibrate and may result in excessive machine vibration
during the spin cycles and loss of performance.
• The washer should be plugged into a properly grounded
(3) prong electrical outlet capable of 120 Volt, 60 Hz, and
11 Amp. It shouldn’t be controlled by a wall switch or pull
cord which could be turned off accidentally. For your safety,
the third or round grounding prong must never be
removed. DO NOT USE AN EXTENSION CORD.
• DO NOT install or store this appliance where it will be
exposed to weather or in an area where gasoline or other
flammables are stored.
Final installation checklist
• Instructions and Installalion Kit have been
removed from the tub.
• Shipping straps have been removed.
• Washer is plugged into electrical outlet and is
properly grounded.
• Water hoses are connected to the faucets with
inlet screens and washers
• Water is turned on and checked for leaks at
faucet and water valve connections.
• Drain hose is properly located into drain
facility and is not collapsed or damaged.
• Washer has been leveled.
• Test for proper operation by running the
washer through a complete cycle at max
temperature.
• Shipping bolts removed.