Bell Powersports RevolverEVO Snow - Manual (Page 5)

Figure 9
1. Flip over the Bell Revolver to allow easy access to lower cheek pad snaps
2. Unsnap just the bottom two snaps on right side first (Figure 9)
3. Take the supplied outrigger marked “R” for right and position so the foam surface is facing
towards the rider’s face
4. Align the snap holes on the outriggers with the snaps on the chin bar surface (Figure 10)
Magnefusion™ Breath Box Installation
Figure 10 Figure 11
5. Next, snap the cheek pad back into place with the outrigger sandwiched between the snaps (Figure 11)
6. Repeat process for the left side
7. Now the Revolver breath box is ready to be used